XYZ 500 MIM micro positioner translation stageXYZ 300 micropositioner translation stageIsloated test arm for probing with less capacitanceXYZ 500 TLS manipulator translation stage

  Quater Research and Development - Translation Stages

 

 

Telephone
541-317-8380
 
FAX
541-317-8329
 
Email
sales@quater-research.com

Collet Probe20601 mounted on a 2054520601 mounted on a 20239

Twin 20601 probesCollet Probe holder signal ground signalNew 20601 Probe with BNC connector

Part #20601 (needle included)

The 20601 is isolated near the needle/probe for less capacitance. The clamping collet has three slots for holding the needle at 30, 45, 180 degrees. It is connected to 3 feet of 50 ohm RG 174 coaxial cable ended in a BNC male connector. The tubing is coated copper tubing that can be bent to many positions making a complete custom probe arm. We can manufacture them longer or shorter if a customer needs more or less reach. Please don't bend the arm while attached to a positioner.

Positioners can be damaged by placing too much load or using them as a vice. This arm is not bendable by the customer, especially while attached to the micro positioner. Bending the arm while mounted to the positioner will cause considerable damage to the gibs and slides.

Part #20601-T (needle included)

The 20601-T Triax version is the same physical size as the Coax version. The clamping collet has three slots for holding the needle at 30, 45, 180 degrees. It is connected to 4 feet of 50 ohm triax cable with a 3 lug triax male connecor.

Either probe can be mounted on all of our translation stages using various back plates. The 20545 Suss plate works well as does the 20239 plain back plate that is used in the 20240 and 20249 probe arm holders.

Translation stages, micro positioners and micro manipulators are just some of the semi-conductor equipment we manufacture. Please contact us for any of you wafer probing needs. Probing is our specialty. We build micropositioners for many manufacturers of probers.

Positioners can be damaged by placing too much load or using them as a vice. This arm is not bendable by the customer, especially while attached to the micro positioner. Bending the arm while mounted to the positioner will cause considerable damage to the gibs and slides.

 

There are drawings of these parts located in the drawing directory.

 

Send mail to sales@quater-research.com with questions or comments about this web site.
Last modified: 03/14/09